Accent lighting works best when the desired effect, mounting surface and power source are planned together. Under-cabinet tape lights, puck lights, shelf lighting and cove systems can look similar after installation while using very different drivers, connectors and controls.
NY-GoodHome handles accent-lighting requests in Brooklyn and New York City. Call (223) 226-1828 with the lighting product, photos of the area and the intended power method.
Under-Cabinet, Cove, Shelf or Display Lighting?
The location determines how visible the fixture and wiring will be. Under-cabinet lighting may need to avoid appliance heat and backsplash interruptions. Shelf lighting can require small cable paths. Cove lighting depends on the geometry of the architectural detail.
If the project is part of new kitchen cabinetry, coordinate the lighting with the cabinet layout before assuming the final wire route.
Plug-In, Low-Voltage or Hardwired?
Plug-in and some low-voltage systems can be product-installation work when the power source already exists. Hardwired drivers, new circuits or line-voltage changes require electrical scope that must be confirmed separately.
The product specifications should be reviewed before installation so a lighting kit is not treated as compatible with a control or driver it was not designed to use.
Dimmers and Smart Controls
Dimming and smart control depend on compatibility between the lights, driver and control device. A dimmer should not be added based on appearance alone.
If the project mainly involves replacing a wall switch or dimmer, use the dedicated control page.
If the same project also includes Light Fixture Installation & Repair or Light Switch & Dimmer Installation & Repair, mention those needs up front so the work can be coordinated without mixing the scopes.